WHY ?

THE LARGEST
SHOP IN JAPAN

EXCLUSIVE COUPONS,
SALE, DEALS

FAST, RELIABLE
SHIPPING

* The BEST and MUST store to find Japanese parts.
* Register now for amazing deals and other special offers!
* Over 800,000 listed items. It's hard NOT to find your parts.

OR
YOUR ACCOUNT HAS BEEN CREATED!

Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online shopping experience with us. If you have ANY questions about the operation of this online shop, please email Webike through CONTACT US.

A confirmation has been sent to the provided email address. If you have not received it within the hour, please contact us.

Get on your grid by register your motorcycle!
About our "My bike" service
"Easier to Search Items"
It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information"
It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register"
It requires only your motorcycle manufacturer, model name and model year!

KAWASAKI Ninja ZX-14R (ZZR1400)


TANAX Cowling Mirror 6

Bought the TANAX Cowling Mirror 6 to replace my oem side mirrors. Easy to install instructions, very versatile in every angle unlike the oem mirrors.
However I replaced the original screws supplied with stainless steel screws to prolong the life of the screws and to prevent rusting of the origin...

GIVI Easy Lock简易固定座(油箱包) BF04

Without this Easy Lock TanClock can not be installed so it is only a part to buy.Part of Main was warped rather than flat, so I thought of turning in a moment.Ninja 1000 '15 MODEL, opening and closing of filler opening was OK without installation problem. A friend of the current Z1000 seems that...

BABYFACE 骨架防倒球

I used OverRACING, but because it is hard to remove the SIDE fin, I replaced it with this product. Easy to remove as it leaves the center of the fin. Since the product of Over gets out from under one, it scratches and struggled to remove the fin. However, because it is above the product of Over, whe...

TANAX Cowling Mirror 6

OEMMirror's visibility was bad so I exchanged it.After exchanging, I ran several times and adjusted, but it will be difficult to see blurred Mirror from about 80 km / h. Especially Right Side becomes hard to see. Stopping the Mirror If you tighten the Screw tightly by diverting the OEM, the shak...

DAYTONA 放空气螺丝

The shape of the tip is slightly different from OEM. I feel a sense of incompatibility when I put on Rubber cap.Seal tape winds in the reverse direction, not in the tightening direction.Noticing that Brake fluid seeped out of Caliper's Air breederRust was amazing as I removed it. Indeed when I t...

NGK 标准型火星塞 CR9EIA-9

Purchased because use of Iridium plugs was specified as Manufacturer.It is stable quality.However, saving a little if it is cheaper.6 thousand yen in 4 pcs...

OVER RACING 竞赛型滑行块(防倒球)

Compared to other Manufacturer's Slider, it is not attached to direct, so it seems to escape shocks well!Also, in the case of 14r, the Slider of Over comes to a lower position than other Manufacturer, so even if you defeat it by eggs etc., Cowletc. It is likely that scratches will be less.Gold a...

DAYTONA 放空气螺丝

Noticing that Brake fluid seeped out of Caliper's Air breederRust was amazing as I removed it. Indeed when I thought this was dangerous, I found this productReplaced. As I wrote that the installation was to tighten Seal tape one half turn and tightenI rolled Emon's Seal tape. It looks more m...

DAYTONA 铝合金切削加工 可调整 煞车拉杆

In the past I was using a certain U ~ Lever, but Brake's effective Timing is different, I'm worried with the corner of LeverWas itMr. DAYTONA likes it because it works with Timing which is almost the same as OEM, and I feel like I did not care about it, so I like it

ALBA G GRIP Slip-resistance Seat Replacement Servi...

Seat which was completed was sent back, and when opening it, I first cared about Wrinkle. OEMSeat is not possible Wrinkle. I used it several times, but Wrinkle will not go away. I do not think that we are pulling out hands, but would not it be better to make the final check after work a bit more str...
(0.0)
(4.0)
(0.0)
(4.0)
(5.0)
(4.0)
(4.0)
(3.0)
(0.0)
(0.0)
(4.0)
(4.0)
(4.0)
(4.0)
(0.0)
(0.0)

最近浏览的商品