通过将其移动到离正常位置10mm的位置,它是专门为每辆车设计的。
在普通车把形状的基础上,将握把部分设计成平行移动。
由于角度和普通的一样,可以在不牺牲形象的前提下形成良好的骑行姿势。
不需要更换电缆
它们是为特定型号的车辆设计的,所以你不会知道,直到你安装它们......。你不用担心 "怎么办"。
铣制的开关孔
无需再为定位和工具准备而烦恼或不必要的费用。
杠杆支架可以左右滑动
安装线设计为长约5mm。
杠杆的位置可以进行微调。
Specially designed for models with a comfortable position by moving it forward about 10mm compared to the normal position.
The design is based on the stock handlebar shape, but the grip part has been shifted in parallel.
The angle is the same as the stock one, so you can form a good riding position without damaging the image.
■No need to replace cables
It is designed for exclusive use of the model, so you don't have to worry about compatibility.
*Depending on the model, it may be necessary to change the minimum cable routing.
*The cables may need to be replaced separately.
■Switch hole pre-machined
You no longer need to worry about positioning and preparing tools, and you no longer need to spend extra money.
*Some models may not have a switch hole.
■Shift the lever holder to the left or right
The mounting straight line is designed to be about 5mm longer.
The grip position of the lever can be fine-tuned.